25' Lag Switch for PS4, PS3, PS2, Xbox One, 360 & PC - [Foot Pedal] Cat5e 1gbps

Description

This lag switch is a 25' foot long Cat5e cable with a foot pedal momentary switch installed into the middle of the cable.
From one RJ45 connector to the foot switch is approximately 12.5' feet.
Foot pedal design allows for more seamless use of the lag switch while also removing the need for bulky lag buttons being taped to your controller.
The cable used is premium Remee Cat5e 24AWG UTP and has booted/snagless RJ45 jacks. Requiring a commercial vendor, this brand name Remee cable provides a guaranteed 1gbps bandwidth with less crosstalk than cheaper alternatives.
Have any questions, issues, or a suggestion? Send a message!
Need a custom lag switch with a longer or shorter cable? Send a message!
Different lag switches
Send a message
Proper network set-up below:
Modem or Router (depending on source of internet) –> Lag Switch –> Network Switch –> Ethernet Cable –> Xbox360/One,Playstation3/4,PC
Every powered network switch I have tested has worked perfectly but I can not vouch for your specific setup.
I personally use a Netgear G605v5 which can usually be found under on eBay.
Note - You will need to buy a network switch to use the lag switch properly. No where in the description does it say to connect this directly into your Xbox360/One/PS3/4/PC. If you connect this directly to your Xbox360/One/PS3/4/PC it will immediately disconnect you. Please refer to the picture gallery for a visual diagram.